Copper manifold part deux

Copper manifold part deux

Post by Bill Buchana » Sun, 04 Feb 2001 13:59:45



Thanks to all that helped me out last time.  I'm almost there.  I've created
a custom bulkhead fitting, similar to the one by John Palmer and I have a
rectangular manifold in the cooler.  I've got the initial rectangle and I'm
going to place another pipe down the middle, that's when I run into a
"duh!".  The duh is, how to connect a piece of 1/2" copper pipe to a 3/8"
nylon barb?  Is there a brass fitting?  Do I use tubing (plastic)?  Any
suggestions are appreciated.