Using Aerotech Igniter Clip with First Fire Igniters

Using Aerotech Igniter Clip with First Fire Igniters

Post by Pete » Mon, 06 Aug 2001 06:51:00



Is there a way to be able to use the Aerotech Igniter Clip with First Fire
Igniters and Copper Heads?  Or should I just cut the Clip off and use single
pincher clips on each lead?  If I do that can I just clip both pincher clips
to a Copper head igniter?  Just asking because a lot of the motors on the
shelves still come with Copper heads.  So it would be nice to accommodate
both igniters until the one is phased out.

Pete

 
 
 

Using Aerotech Igniter Clip with First Fire Igniters

Post by Christopher Dee » Mon, 06 Aug 2001 09:15:25


You can use regular micro clips with copperheads, just wrap tape around one
jaw of each clip. Put the unwrapped jaws on opposite sides of the
copperhead. Or, put small pieces of tape on opposite sides of the
copperhead, making sure the tape is not lined up. Or, some people heat the
end of the copperhead with a match or a lighter, delaminating it. Then you
have two copper strips to attach the clips to.

--
Christopher Brian Deem       NAR 12308 TRA 2256 Level II

Quote:
> Is there a way to be able to use the Aerotech Igniter Clip with First Fire
> Igniters and Copper Heads?  Or should I just cut the Clip off and use
single
> pincher clips on each lead?  If I do that can I just clip both pincher
clips
> to a Copper head igniter?  Just asking because a lot of the motors on the
> shelves still come with Copper heads.  So it would be nice to accommodate
> both igniters until the one is phased out.

> Pete