Kyosho nexus 30 directions wrong??

Kyosho nexus 30 directions wrong??

Post by Jon » Fri, 10 Aug 2001 11:53:02



The directions for my nexus 30 say that the stablizer rod should be 27mm,
the pitch rod should be 39mm, and the stabilizer control rod should be 49mm,
The stabilizer and te pitch rod fit but the stabilizer control rod is way to
short, it will only reach if the swash plate is turned all the way to the
right and i spin the stablizer the other way, needless to say it wont fly
like that, and then the rod on the other side is even farther away from
fitting correct.  Anyone elese buy this heli and have the same problem?  Any
ideas on what the bleep to do?

Thanks
buzz1167
Jon N

 
 
 

Kyosho nexus 30 directions wrong??

Post by Marcin Romaszewic » Sat, 11 Aug 2001 03:42:38


There is a supplementary sheet that comes with the instructions which
lists errors they've made. One of the errors is the lenghth of one of
the rods on the head. Check out
http://www.heliguy.com/rcheli/index.html. He has a nexus manual and the
supplement scanned in.

I had a similar problem when I was building my nexus (never touched
anything with a remote before). It turned out that I was being dumb and
didn't have my head all the way down on the mast. The scew cleared the
top of the mast and didn't go through the hole; doublecheck that. It
could explain why linkages are so far off.

-- Marcin

Quote:

> The directions for my nexus 30 say that the stablizer rod should be 27mm,
> the pitch rod should be 39mm, and the stabilizer control rod should be 49mm,
> The stabilizer and te pitch rod fit but the stabilizer control rod is way to
> short, it will only reach if the swash plate is turned all the way to the
> right and i spin the stablizer the other way, needless to say it wont fly
> like that, and then the rod on the other side is even farther away from
> fitting correct.  Anyone elese buy this heli and have the same problem?  Any
> ideas on what the bleep to do?

> Thanks
> buzz1167
> Jon N