Help! Tamiya Chevy S-10 1/10 electric

Help! Tamiya Chevy S-10 1/10 electric

Post by Domin » Fri, 30 Aug 1996 04:00:00




Quote:
>I just bought this truck and it's my first.  I was able to put it all together
>without problem, however it doesn't include the servo's.  I bought a used
>car from someone and it had 2 servos and I installed them into the Chevy.
>The servo's work, but when I connect the battery, the servo goes completely
>to one side.

1. Undo the servo arms from the serovs.  

2. Turn on the radio equipment and zero out the trim knobs.  

3. Reattach servo arms to the servos.

Hope this helps!

   Newly updated home page...http://www.pacifier.com/~dtuso
                            _______________________        _____
_________ _______  ________ _______  /______  /___(_)_________  /_
 __/ ___/ _  ___/   __  __ `/_  __  / _  __  / __  / _  ___/_  __/
 _/ /     / /__     _/ /_/ / / /_/ /  / /_/ /  _  /  / /__  / /_  
 /_/      \___/      \__,_/  \__,_/   \__,_/   /_/   \___/  \__/  
                           Dominic Tuso
                    Vancouver, Washington, USA

 
 
 

Help! Tamiya Chevy S-10 1/10 electric

Post by Robert T. Timmo » Fri, 30 Aug 1996 04:00:00


I just bought this truck and it's my first.  I was able to put it all together
without problem, however it doesn't include the servo's.  I bought a used
car from someone and it had 2 servos and I installed them into the Chevy.
The servo's work, but when I connect the battery, the servo goes completely
to one side.  I can control the servo's to a degree with the remote, but I
can't seem to get it to work properly.  The same thing's happening on
both servo's.  Any suggestions would be greatly appreciated.


Robert Timmons
CNE-to-be...