dremel bit on normal drill

dremel bit on normal drill

Post by Grizzbob » Tue, 26 Aug 1997 04:00:00



They might on some drills, but they probably won't be of much use, because
they're intended to spin at higher speeds than normal drills are designed
to run. You'd be best off to get a Dremel, & you might try getting help
from your family in paying for it, they do have MANY more uses than just
on R/C vehicles.

 
 
 

dremel bit on normal drill

Post by Wonko the Sa » Wed, 27 Aug 1997 04:00:00



professed:

Quote:
>does anybody know whether or not the bits from the dremel rotary tools will
>fit on regular drills?  i want to get a cutting disk and some other stuff
>from tower hobbies but they are for the dremel.

>thanks

>vic

Yeah, they'll fit. The dremel mandrel is 1/8 inch. Your drill might
not spin fast enough to take advantage of some of the bits though.

--
In the beginning the Universe was created.
This has made a lot of people very angry
and been widely regarded as a bad move.

I ditched the NOSPAM