Making holes in glass bottles

Making holes in glass bottles

Post by orbw.. » Thu, 07 Sep 1995 04:00:00



The easiest way to do what you're wanting to do is to aquire a glass grinder
or router.  This is a self-cooling (water) device that can hold a variety of
diamond-coated bits.  The hollow-cored bit mentioned earlier has an equivalent in the

router world.  YOu're probably looking at around $125 or so.  If this is too much then you can create a
wax or clay "dam" around the place you want the hole, fill it with water, and use
a glass bit to slowly work your way through the glass.  Remember, when
dealing with glass the watch-words are "slow" and "careful".

I hope this post comes out ok, I hate this particular news reader.

Bryan "first posts" Paschke